Repareer je spullen Gemeenschap Winkel

修复死亡黄灯

Terug naar de handleiding
Engels
Chinees
Stap 3
Yellow Light of Death Repair: stap 0, afbeelding 1 van 1

  • Set the heat gun to "Low" or around 300C (575F), and let it run for a few seconds to reach operating temperature.

  • Holding the motherboard upright, warm up the entire board with the heat gun. The board should be warm, but not too hot.

  • This will prevent damage to the board caused by localized thermal expansion.

将热枪设置为“低”，让其运行几分钟以达到工作温度。

握住主板使之直立，用热枪加热整个主板。 主板会变得暖，但不要使之太热。

这样可以防止局部热膨胀引起的主板损坏。

-[* black] Set the heat gun to "Low", and let it run for a few seconds to reach operating temperature.
+[* black] Set the heat gun to "Low" or around 300C (575F), and let it run for a few seconds to reach operating temperature.
[* black] Holding the motherboard upright, warm up the entire board with the heat gun. The board should be warm, but not too hot.
[* icon_note] This will prevent damage to the board caused by localized thermal expansion.

Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.

OSZAR »